“We haven’t had one single problem in seven months now with our temperatures at all.”
That is Matt, co-owner of Rebuild Recovery in Norwood, South Australia, describing a venue with four plunge pools held at different temperatures and used heavily every day. Several suppliers told him it would be difficult and expensive. Anthony at Adelaide Pool Heating designed the system that proved otherwise.
The challenge: Four temperatures, heavy daily use
Rebuild Recovery offers hot and cold therapy alongside saunas, compression and red light therapy. Matt wanted pools at several temperatures rather than just one very cold and one very hot, because a jump from 5°C to 40°C can leave people dizzy or uncomfortable. Stepped temperatures let members build up gradually.
The difficulty was keeping each pool exactly where it was set. Matt was told he would need special freezers, and the cost looked high: “You start looking at it and you think, ‘Wow, it’s going to cost a lot of money just to have one cold at that temperature.'”
The solution: One heat pump per pool
Anthony specified a separate heat pump for each pool, matched to the temperature that pool had to hold. Four decisions made the difference.
Roof-mounted units. Driveways and car parks left no room at ground level, so all four heat pumps went on the roof. Anthony says that suits the equipment: “You get hot air to it and you get the cold air away.” Each unit gets the air it needs, and the cooler exhaust air moves clear.
Pest-resistant heat pumps. Anthony chose pumps deliberately, that he describes as the most pest-resistant heat pump on the market. Pests reaching the control board is a growing problem for heat pumps. “They short circuit the boards, damage the boards.” The pumps at Rebuild Recover have boards sealed against anything over one millimetre.
A yearly maintenance plan. Norwood is leafy, and leaves and debris collect around outdoor units. Anthony set up an annual visit to check and clean each heat pump, because “the more efficient we can have them running, the better it is.”
Pool covers overnight. Anthony also suggested covers on each pool. A heat pump only works hard while the temperature is changing, so a cover that holds the temperature overnight means less running time. Matt says it “does save a lot of energy.”
The result: Seven months, no breakdowns
- Matt has not touched the temperatures, apart from raising the warm pool from 30°C to 36°C in winter when members asked for it. “I haven’t touched the temperatures, not once.”
- Around 200 members came through in three days, with sessions booked out for up to eight hours straight. The pools moved by only a degree or two.
- None of the heat pumps have broken down.
- Interstate visitors have told Matt his pools are “spot on temperature”, unlike centres where a pool set to 5°C feels closer to 10°C.
- Matt checks and adjusts temperatures from an app on his phone, which helps when the units sit four to five metres up on the roof.
Matt is now planning two or three more centres in Adelaide. “He’d be my first guy to go through with the pumps, for sure.”
What this means for your swimming pool
You may not be running four plunge pools, but the same principles apply to a family swimming pool in Adelaide.
- Match the heat pump to your swimming pool and how you use it. A system sized to the job holds its temperature without running harder than it needs to.
- Give the unit good airflow. A heat pump works best with a steady supply of air and room for the cooler air to clear. Where ground space is tight, a roof can work.
- Ask about pest resistance. Damaged control boards are an increasing cause of heat pump problems, and a sealed board design helps prevent them.
- Cover your swimming pool overnight. A cover reduces heat loss, so the heat pump uses less energy to hold your temperature.
- Book an annual service. Cleaning leaves and debris from the unit keeps it running efficiently, especially in leafy suburbs.
- Choose app control. Checking and adjusting the temperature from your phone means you rarely need to touch the unit.
Talk to Anthony
If you are planning a new pool heating system in Adelaide, or want to improve the one you have, Anthony at Adelaide Pool Heating can talk through what suits your swimming pool. Contact Adelaide Pool Heating today.
Related Posts
UPDATE: Original post from October 2021 but now another hail event, this time in October 2026. The same lessons are here to be learned, and..
One of the most common questions Anthony receives from new customers considering a swimming pool heating solution is this: “The cover sounds great, but how..
If you use your Adelaide swimming pool just four times a year, gas pool heating might be your smartest choice. If you swim four times..